Boards

Every board in the range, with the specs it is designed to. Statuses are honest: a design that is frozen says so, and so does one that is still on the bench.

Coming soon

Designs are frozen and headed for the first batch.

Horizon

Main board

The ESP32-S3 brain of the family. Takes your battery voltage directly and gives every other board something to plug into.

Zephyr

Air and motion sensor

A small round Qwiic board that tells you how the air in your van is doing, and whether the van is level.

Prototype

On the bench. Specs may still shift.

Meridian

Battery monitor

Current, voltage and state of charge for your house battery, read over Qwiic.

Solstice

Power distributor

A quiet, passive 12 V rail with two fused outputs. No firmware, nothing to configure.

Eclipse

Load switch

Switches a heater mat, pump or fridge from ESPHome. If anything goes wrong, it fails off.

Aurora

LED dimmer

Smooth dimming for plain analog LED strips, including warm and cool white, controlled over Qwiic.

Pulsar

Addressable LED driver

Level-shifts and powers addressable strips so ESPHome can run effects on them.

In the making

Started, but early.

Renogy Modbus

RS-485 interface

Reads your Renogy gear over two independent RS-485 lines, one RJ45 each.

Multi-channel Eclipse

Load switch, more channels

The same fail-off relay idea with more channels on one board.

Renogy inverter controller

Remote inverter control

Switch your Renogy inverter on and off from ESPHome and read its status LED, while keeping the original wall panel.